[slinkelist] Launching CDJ Via Batch File

[Colby Boles]

If you wrote a program which used SlinkX to talk to the CM11a and launch
CDJ, then CDJ could also use the CM11a. Why not run CDJ all of the time and
just use X10 to map to the cdj:sleep and cdj:awaken commands?

Colby

> -----Original Message-----
> From: slinkelist-admin@nirvis.com [mailto:slinkelist-admin@nirvis.com]On
> Behalf Of Tang, George
> Sent: Monday, July 10, 2000 10:25 AM
> To: Marc Parker; slinkelist@nirvis.com
> Subject: RE: [slinkelist] Launching CDJ Via Batch File
>
>
> That would be a problem, because for that to happen, you'll need
> some other
> software to be listening from the cm11a computer module for your x-10
> command in order to launch CDJ.  Then you'll need to disable that software
> before CDJ runs in order for it to see the cm11a since only 1 software can
> have access to the cm11a serial port at a time.  Unless you don't want CDJ
> to have control of x-10, then that's not a problem.  But either
> way, you'll
> need to write a custom software to be the initial x-10 listener.
>
> -G
>
> -----Original Message-----
> From: slinkelist-admin@nirvis.com [mailto:slinkelist-admin@nirvis.com]On
> Behalf Of Marc Parker
> Sent: Friday, July 07, 2000 10:37 PM
> To: slinkelist@nirvis.com
> Subject: [slinkelist] Launching CDJ Via Batch File
>
>
> I am interested in launching CDJ via an ascii out from a home automation
> controller (Stargate). I understand this can be done using a
> batch file, but
> am not proficient in their use.
>
> I ultimately want to be able to start up CDJ from an X-10 command.
>
> Can anyone help out on this....
>
> Thanks
> Parker
>
>
>
> _______________________________________________
> slinkelist maillist  -  slinkelist@nirvis.com
> http://www.nirvis.com/mailman/listinfo/slinkelist
>
>
>
> _______________________________________________
> slinkelist maillist  -  slinkelist@nirvis.com
> http://www.nirvis.com/mailman/listinfo/slinkelist
>
>