[slinkelist] Slink-e problems with external receiver modules

[Colby Boles]

1. The Slink-e uses data-type cables which are wired straight through.
Telephone cables cross wires internally. You can get data-type cables at
Radio Shack.

2. Once you have attached an external receiver, you need to run Slinkeserv
and go to View | Settings. From there you need to click on the red X which
corresponds to the receiver input you are connected to and enable it. Then
choose Save to RAM and EEPROM, then Exit.

Colby

> -----Original Message-----
> From: slinkelist-admin@nirvis.com [mailto:slinkelist-admin@nirvis.com]On
> Behalf Of Max Spring
> Sent: Monday, June 26, 2000 9:34 PM
> To: help@nirvis.com; slinkelist@nirvis.com
> Subject: [slinkelist] Slink-e problems with external receiver modules
>
>
> I have problems in getting an external receiver module to work with the
> Slink-e:
>
> Most of my telephone cables don't work at all.  I guess either
> because they
> don't have 4 conductors, or they have it in the wrong order.
>
> By using one particular cable (presumably the one I got with the
> Slink-e months
> ago) shows some sign of life: Whenever I plugin or unplug a
> receiver module,
> the control LED flashes.  Also when I send IR signals to that module, the
> control LED flashes, too.
>
> However, the Slink-e doesn't seem to notice anything of it.
> Whereas, using the
> build-in IR receiver works great.
>
> I'm confused.  I'd appreciate if someone could help me further.
>
> Regards,
> -Max
>
>
>
> _______________________________________________
> slinkelist maillist  -  slinkelist@nirvis.com
> http://www.nirvis.com/mailman/listinfo/slinkelist
>
>